MaxxFlow HTC – Mass Flow Measurement for Dry Bulk Solids

The MaxxFlow HTC:

• Most non-metallic solids can be measured      
• Can be installed on round pipes or ducts     
• No real upper limit of mass flow     
• Dust-tight     
• No flow restrictions to the process flow (wear-resistant ceramic liner)     
• The mass flow measurement is independent of flow characteristics     
• Maximum temperature: 12O °C     
• Can be installed at an angle     
• Small installation height, max. 310 mm     
• No moving parts, hence no maintenance    
• Easy to calibrate

The MaxxFlow HTC is specially developed for the flow measurement of dry bulk solids during high-volume throughput. Due to its completely open profile and its low installation height, the MaxxFlow HTC is especially suitable in situations in which it was previously only possible to use complicated or expensive mechanical solutions, e. g. impact plates or measuring chutes.

The installation of the MaxxFlow HTC takes place independently of the direction of the line (vertical/inclined), but always after mechanical conveyor elements, e. g. rotary feeder, screw conveyors, air slides, or chain conveyors.

This article is published by ENVEA Process GmbH

ENVEA Process GmbH specializes in measuring systems for bulk material and solids: Measurement of mass flow, moisture, dust and velocity as well as level detection ,flow/no flow detection and screen break detection. Good and simple solutions – for a wide range of industries involving the processing of solid materials. Made in Germany.

ENVEA ...

View company page